15.11.7  LIMITED 

Specifies  which  data are to be binned.  If limits are not specified, the
default is the current plot limits.  See:Command SET LIMITS.
     1.  X - Specifies X limit
     2.  Y - Specifies Y limit
     3.  Z - Specifies the Z limit
     4.  CURSOR  - Brings up the cursor.  You move it to the X,Y value you
         wish then press the space bar to enter both X,Y or X to  enter  X
         or Y to enter Y.
     5.  RECURSOR - The cursor enters both limits.

                                  Example
     TD:BIN LIMITED FROM X=1 to X=5
Sets limits on the range of X data to bin.
     TD:BIN LIMITED FROM 1,5.5 TO 5,50.8
Sets  limits  on  the range of X,Y to bin.  This does not set the range of
the final data sets.